Noyafa NF-300 Uživatelský manuál

INSTRUCTION MANUAL INSTRUCTION MANUAL INSTRUCTION MANUAL INSTRUCTION MANUAL ORIGINAL AU T H E N T I Cd prodnteuctetsa,Png noeitit arfltelonwueodCORIGI

d. Crosstalk testAs shown the figure below: it shows 3, 6 and 4, 5 with crosstalk. The line pair with crosstalk will flash to indicate failure.

NOYAFANOYAFAUSB BNCSetup17Unit :When moving cursor to “Unit” item, choose “meter”,The following interface will be shown:

1. Emitter 1PCS2. Receiver 1PCS4. Earphone 1PCS6. RJ45 Adap

Please read and learn safety instructions before use or maintain the equipment●Keep the testers in righ t place to avoid hurt with th e sharp probe. ●

● connection and broken wire positioning ( RJ11,RJ45, BNC C ). ● To perform crosstalk test on network cable to solve the potential problem o

03(5).Detecting cable typesSTP/UTP 5E, 6E network cable, telephone cable, coaxial cable, USB cable and common metal wires connected with alligator cli

NOYAFAProduct operation method5 seconds later, the following main interface is displayed: BootscreenSynchronous self test ( self test dynamically disp

07Note: Because network cable is made of pair cores, if there is open circuit, it will show faults in pairs, just as above "4" &" 5

09Special use: can test line sequence of the connecting cablesIn case of exchanger power-on, the main unit Take network cable as an example: on

11Test result 5: BNC cable length testIf to insert one end of the BNC cable to be tested into “BNC” port of the main tester, the other end is an open

1.Tracing cable (RJ45/RJ11 Cable) which is connected to switch or router. Insert the cable into port RJ11/ RJ45 (S), Press the testing key of recei