Noyafa NF-8200 Uživatelský manuál

INSTRUCTION MANUAL INSTRUCTION MANUAL INSTRUCTION MANUAL INSTRUCTION MANUAL ORIGINAL AU T H E N T I Cted produenctats,Png noteiti arfllteonwueodCORIGI

d. Crosstalk testAs shown the figure below: it shows 3, 6 and 4, 5 with crosstalk. The line pair with crosstalk will flash to indicate failure.

17Unit :Move to “Unit” item, choose “meter”, “ ” then the screen will be as below: Note: Setup of the unit of inch

1. Emitter 1PCS2. Receiver 1PCS4. Earphone 1PCS6. RJ45 Adap

Please read and learn safety instructions before use or maintain the equipment●Keep the testers in right place to avoid hurt with the sharp probe. ●Ne

01Overview NF-8200 is capable of avoiding current inteference . The equipment is composed of three parts: main tester (NF-82

03(5).Detecting cable typesSTP/UTP 5E, 6E network cable, telephone cable,and common metal wires connected with alligator clip. (6).Operating environm

Product operation method5 seconds later, the following main interface is displayed: BootscreenSynchronous self test ( self test dynamically displayed

07Note: Because network cable is made of pair cores, if there is open circuit, it will show faults in pairs, just as above "4" &" 5

09Special use: can test line sequence of the connecting cablesIn case of exchanger power-on, the main unit Take network cable as an example: on

111 Open 1 0. 1m 4 Open 1 10. m 2 Open 1 0 0. m 3 Open 1

1.Tracing cable (RJ45/RJ11 Cable) which is connected to switch or router. Insert the cable into port RJ11/ RJ45 (S), Press the testing key of recei